9
Subject to change without notice | 83057000jUK – Translation of the original operating manual | ait-deutschland GmbH
Cooling
Cooling is integrated in type K units. Type H units can
The following options are possible for units with
cooling function ( operating manual of the heating
and heat pump controller):
Passive cooling (without compressor)
Control of the cooling function via the heating and
heat pump controller
Automatic switching between heating and cooling
mode
The control can be connected to a computer or
pump controller can then be controlled from the
4 Operation and care
NOTE
The unit is operated via the control of
the heating and heat pump controller
( operating manual of the heating and heat
pump controller).
4.1 Energy and environmentally
aware operation
The generally accepted requirements for energy-
aware and environmentally-aware operation of a
heating system also apply to use of a brine/water heat
pump. The most important measures include:
No unnecessarily high domestic hot water
temperature (note and follow local regulations)
Do not open windows with gap /tilt open
(continuous ventilation), but instead open wide for
a short time (purge ventilation)
4.2 Maintenance
Wipe down the outside of the unit only using a damp
cloth or cloth with mild cleaning product (washing-up
liquid, neutral cleaning product). Do not use any harsh,
abrasive, acid or chlorine-based cleaning products.
5 Delivery, storage, transport
and installation
IMPORTANT
Damage to the housing and the unit components
due to heavy objects.
Do not place any objects on the unit which are
heavier than 30
5.1 Scope of supply
NOTE
On delivery the accessories are enclosed in
outwardly visible damage and completeness.
Notify supplier of any defects immediately.
3 of this manual
6-mm anchors with screws (2x each) for wall-
mounting the control unit
Safety valve, outdoor sensor
Replacement material after dismantling the
module box:
Insulation hoses (2x)
Cable ties (4x)
seal (1x)
O-rings (8x)
(3x)
To Next Page
Loading...
Need help?
General
