16
We reserve the right to make technical changes.
UK830509/200114 © Alpha-InnoTec GmbH
NOTE.
A connection to a computer or a network
can be installed via the left bushing on
the bottom of the control element, thus
allowing the heating and heat pump
regulator to be controlled remotely. One
pre-condition is that a screened network
cable (category 6) be installed through the
unit when installing the unit.
Operating manual for the heating and heat pump
regulator, version “Qualied technician”, “Web
server” section.
If this network cable is available, insert
the network cable’s RJ-45 plug into the
left bushing of the control element.
NOTE.
The network cable can be exchanged at
any time. In order to be able to connect it,
the screen must rst be removed.
Installation and removal of the
screen
installing the sCReen
NOTE.
The screen is provided at the time of
delivery so that the control element may
be inserted in the upper recesses of the
front facade.
If the control element has been inserted in
the lower recesses of the front facade, you
must rst remove the screen’s temporary
cover and then reinsert it above the logo.
Screen at time of delivery:
1 recess for control element
2 logo
3 temporary cover
First, insert the screen below, in the provided slots
on the front of the facade…
To Next Page
Loading...
Need help?
General
