Service manual AlphaCom XL transceiver Rev. 1.4 10-08-2011 Blz. 55/74
The flash software will try to establish a connection with the microprocessor on the AlphaCom XL.Once the
connection is established a green text „Connection complete‟ will appear in the text block:
After the connection is established, the software will flash the new firmware into the microprocessor of the
AlphaCom XL. The blue completion line above the text block shows the percentage of completion. After the
new firmware has been fully flashed into the microprocessor a green message „Image successfully written to
device‟ will appear in the text block.
To Next Page
Loading...