Press the <#> key to confirm.
F8# Start remote programming
To start remote programming, function 8 can be executed. This will make the analogue dialler of the
AlphaVision NG call the 9th callback telephone number, which should dial to the service number of the
installation company. To perform remote programming, make sure an AlphaVision RS-box and the
AlphaManager software (minimal version 3.0) are present at the installation company. Connecting to the PC
at the installation company can take up to 10 minutes.
To activate the remote programming function, press <?> <8> <#>, followed by a level 5 user code.
The following message will appear on the display:
Start up/down-
loading? (#=yes)
Press the <#> key to confirm or the <*> key to leave this function. If up/downloading will be done using the
ISDN line and the connected ISDN dialler (AlphaCom) has a problem to start this up/downloading session,
this will be mentioned on the display like:
ERROR: no call-
backnr. present
ERROR: AlphaCom
is busy. (ISDN)
Up/downloading on an ISDN-line is only possible using a Point-to-Multipoint line, not on a Point-to-Point
line and also not in combination with X.25 transmission.
F9# Display historical overview
Using function 9, the contents of the event log can be viewed from the LCD display. The event log registers
the last 100 events.
Press <?> <9> <#>, followed by a level 4 or 5 user code. The following message will appear on your
display:
Historical over-
view:
Use the <↑> key to scroll up and use the <↓> key to scroll down. Scrolling up will bring you to previous
events, (most recent event number is 100) scrolling down will bring you to the more recent events (oldest
event number is 01).
All events are split up into two screens on the LCD display. The first screen shows the type of event, the
second screen sows other information, such as date and time, which user caused the event (in case of an
arming or disarming), and for instance which section was armed or disarmed.
The first screen on your display is showed as:
DISARM
................
By pressing the <↑> key, the second screen can be viewed:
A....... 001
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 72/101
We 03 Oct 12:58
To Next Page
Loading...