Alpine Spas MUNRO - Spa Pool Operation

24
Understanding the Display (Topside Control Panel)
Whenthespapoolisrstpoweredandpriminghascompleted,thedefaultdisplay
willshowthecurrentwatertemperature-thisisreferredtoasW.TMP(water
temp).Youcancyclebetweenthebelowthreedisplaymodesbyusingthe‘UP’or
‘DOWN’buttons:
W.TMP
Shows the current water
temperature. This is the
default screen.
Cycle through to next screen
with up/down buttons.
Cycle through to next screen
with up/down buttons.
Cycle through to next screen
with up/down buttons.
S.TMP
Shows the SET water
temperature.
TIME
Shows the current set time.
It's important that this time
is set correctly.
It’srecommendedtoleavethedisplayonW.TMPtoseeacleardifferencebetween
yoursettemperatureandyourcurrentwatertemperature.
Post Heat-up
Oncethedefault38°Cisreachedthecirculationpumpwillstopoperatingandwill
onlyre-engageifthespapoollosestemperature,altercyclehasbegunorthe
systemispollingautomaticallytochecktemperature.
Changing the Temperature
Pressingorholdingthe‘UP’or‘DOWN’buttonswilladjustthesettemperature
inthedirectionindicatedonthebuttoninincrementsof0.2°C.Whenthedisplay
stopsashing,thespapoolwillbeginheatingtothenewsettemperature(thespa
poolcannotcoolthewater).Thespapoolisalreadypre-setto38°C.
UP DOWN
6. SPA POOL USAGE GUIDE & TIPS
SPA POOL OPERATION