11-EN
Setting items:
Connection
Setting content:
Connection/disconnected
Connection Settings
1 Connect the USB cable and open the
software, it will automatically go online.
After the connection is successful, the
connection icon will show green [ ].
2 After online, click the connection icon to
disconnect. When not online, the connection
icon will display red [ ], and click the
connection icon again to go online again.
Click [File] to enter the loading or saving scene file
page.
Load or save presets file page
Setting items:
File
Setting content:
Load PC Preset/Save as PC Preset/Load All Presets/
Save All Presets
Load PC Preset
The scene file previously saved on the computer can
be loaded as the current machine working scene.
Save as PC Preset
The current machine work scene file can be saved to
the computer for later recall.
Load All Presets
Load the files of the entire machine previously saved
on the computer to the machine (including the
current working scene, machine preset scene,
output channel configuration data, etc.), and copy
all the machine data that has been debugged to the
currently connected machine.
Save All Presets
Save all data on the current online machine as a
computer file (including the current working scene,
machine preset scene, output channel configuration
data, etc.) for later recall when the whole machine is
copied.
Click [Option] to enter the setting page.
Setting page
<Setting item>
Firmware Update Settings
Select [Firmware Update] from the options page to
enter the firmware update setting page.
Firmware update page
Connection
File Settings
Option Setting
Firmware update
Restore factory settings
Shutdown delay
Language
About
To Next Page
Loading...
Need help?
General
