Alstom MiCOM P545 - 1.4.7.6 Rear port 2 connection settings

Settings P54x/EN ST/La4
MiCOM P543, P544, P545, P546
(ST) 4-83
ST
Setting range
Menu text Default setting
Min. Max.
Step size
NIC Link Report Alarm
Alarm, Event, None
Configures how a failed/unfitted network link (copper or fiber) is reported:
Alarm - an alarm is raised for a failed link
Event - an event is logged for a failed link
None - nothing reported for a failed link
NIC Link Timeout 60 s 0.1 s 60 s 0.1 s
Duration of time waited, d network link cted, be munic on after faile is dete fore com ati
by the alternative media interface is attempted.
SNTP PARAMETERS
SNTP Server 1 SNTP Server 1 address
Indicates the SNTP Ser ress ver 1 add
SNTP Server 2 SNTP Server 1 address
Indicates the SNTP Ser ress ver 2 add
SNTP Poll Rate 64 s
64 s 1024 s 1 s
Duration of SNTP poll ra onds te in sec
DNP3.0 Need Time 10 mins
1 min 30 mins 1 min
The duration of time wa efore requesting a er time syn m the mas ited b noth c fro ter
DNP App Fragment 2048
100 2048 1
The maximum message length (application frag t size) tran by the ay. men smitted rel
DNP App Timeout 2 s 1 s 120 s 1 s
Duration of time waited, sending a messa gment an after ge fra d awaiting a
confirmation from the master.
DNP SBO Timeout 10 s 1 s 10 s 1 s
Duration of time waited, after receiving a select command and awaiting an operate
confirmation from the master.
1.4.7.6 R on s s
T le
with the courier protocol.
Setting range
ear port 2 connecti etting
he settings shown are those configurable for the second rear port which is only availab
Menu text Default setting
.
Step size
Min. Max
COMMUNICATIONS
RP2 Protocol Courier
Indicates the communic ocol that will be used on the rear communications port. ations prot
RP2 Port Config. EIA(RS)232 EIA(RS)232, EIA(RS)485 or KBus
This cell defines whethe ical EIA(RS)2 us is being used for r an electr 32, EIA(RS)485 or KB
communication.
RP2 Comms. Mode
IEC 60870 FT1.2
Frame
IEC60870 FT1.2 Frame or 10-Bit No
Parity
The choice is either IEC 60870 FT1.2 for normal operation with 11-bit modems, or 10-bit
no parity.