Altec Lansing M302 - Listening to the FM Radio; FM Antenna and Reception; Tuning and Selecting Stations; Storing and Recalling FM Presets

12
1 Plug the FM radio antenna into the speaker system’s FM
ANTENNA jack.
Thejackislocatedonthebackofthesystem.
2 Extend the FM antenna wire fully for best FM reception. Also,
do not strip, alter or attach to other antennas.
3 Ensure your speaker system is powered on.
Ifthesystemisn’ton,presstheSTANDBYbuttononthespeaker
system or the
button on the wireless remote.
4 Select “FM” mode.
PresstheSOURCEbuttononyourspeakersystemortheSOURCE
buttononthewirelessremoteuntiltheFMappearsontheLCD.
5 Tune to the station you want to listen to.
Use the
and buttons on the wireless remote to tune in the
desired station.
Pressandholdthesesamebuttonsfor3secondstondthenext
clearFMstation.PressandholdtheAUTObuttononthewireless
remotefor3secondstoautomaticallytuneandsaveallclearFM
stations.
6 Adjust the volume.
UsetheVOLUME+and–VOLUMEbuttonsontheAltecLansing
MoondanceHomespeakersystemtoadjustthesystemvolume.Or,
use the
and buttons on the wireless remote.
NOTE ExtendtheFMantennawirefullyforbestFMreception.Also,donot
strip, alter or attach to other antennas.
How to Store Preset Stations
Your Altec Lansing Moondance Home speaker system’s wireless remote
enablesyoutoprogramupto16FMstationpresets:
1 Ensure your speaker system is powered on.
2 Make sure you are in “FM” mode.
3 Tune to the station you wish to store.
4 Store the station.
PresstheENTERbuttononthewirelessremote.Apresetlocation
will show and begin to flash. The station stored in that preset will be
displayedinthelowerright-handcorneroftheLCDdisplay.
Use the
and buttons on the wireless remote to select the preset
location you want to store the station in.
PresstheENTERbuttontostorethestationinthepresetlocation.
YoucanstoreoneFMstationineachpresetlocation.
5 To store other preset stations, repeat the above steps.
How to Recall Preset Stations
1 Ensure your speaker system is powered on.
2 Make sure you are in “FM” mode.
3 Use the and buttons on the wireless remote to select
the desired preset.
The radio will tune to your preset station.
4 Adjust the volume.
Listening to the FM Radio