Altec Lansing M302 - Troubleshooting - Audio and Remote Issues; iPod Charging and Audio Quality; Wireless Remote Functionality; No Sound from AUX Input

19
EN
Troubleshooting
Symptom Possible Problem Solution
iPod didn’t charge
iPod is not installed properly RemoveyouriPodfromthedockandcheckforobstructionsonthe
connectors in the dock and on your iPod. Then reseat it in the dock.
iPod is locked up Please make sure your iPod is working properly before docking into the unit.
Please refer to your iPod manual for details.
ACadapterisn’tpluggedintoawalloutlet,
or the connector is not plugged into the
powersupplyjackonthebackofthe
speaker system
PlugtheACadapterintoawalloutletandplugtheconnectorintothesupply
jackonthespeakersystem.
Soundisdistorted
Volume level is set too high Decrease the volume.
Soundsourceisdistorted IftheiPodoriginalsoundsource(MP3)isofpoorquality,distortionandnoise
are easily noticed with high-power speakers. Try a different audio source such
asamusicCD.
Wirelessremotedoesn’twork
Batteryisweak Replacecurrentbatterywithanewbattery.
Wirelessremoteisnotpointedtowardthe
speaker system
Point the wireless remote toward the Altec Lansing speaker system and move
within10feetoftheunit.
NosoundfromtheAUX
IN device, such as an
MP3playerorCDplayer
connectedtotheAUXINjack
Volume on the device is set too low Increasethevolumeonthedevicetoapproximately¾fullvolume.
SourceselectorisnotsettoAuxOut SetsourceselectortoAuxOut.