Altec ATP-600 PRO - Calibration; Calibration Setup; Serial; Network

40
+31(0)78 - 615 20 33
info@altec.nl
www.altec.nl
+32(0)2 - 270 34 88
info@altec.
be
www.altec.
be
NL
BE
5.2 Configuration
General
Change general printer settings
Speed
Density
Direction
Code Page
Post-Print action
Cut Piece
Cut Back
Mirror
Head-up Sensor
Reprint After Error
Printer speed (1.5 – 6 inch/s)
Printing temperature (0 - 15)
Print direction (0 or 1)
Keyboard country code
TEAR / PEAL / CUTTER /OFF
Cut after “X” labels
Return media after cutting
Mirrored printing
Top cover open/closed check
Reprint last label after error
Adjust
Set the print and tear-off position
Offset
Reference X / Y
Shift X / Y
Adjust tear-off position
Adjust print and tear-off position
Adjust print position
Media
Label and printer sensor settings
Unit
Paper width
Paper height
Gap Size
Gap Offset
Black Mark Size
Black Mark Offset
Sensor Type
Print Method
Set unit to inch or mm
Media width in millimeters
Media height in millimetres
Gap size (height) in millimeters
Offset distance in millimetres
Black Mark size (height) in millimeters
Offset distance in millimetres
Gap / Black mark / Continuous
Thermal-Transfer / Direct thermal