Altec ATP-600 PRO - Advanced; Z;D configuration; RS232 (serial port)

46
+31(0)78 - 615 20 33
info@altec.nl
www.altec.nl
+32(0)2 - 270 34 88
info@altec.
be
www.altec.
be
NL
BE
6.2 Printer settings
6.2.1 Printer configuration
Select the printer(s) in the list and click on Printer Configuration.
Basic
Apply basic settings to one or all printer(s).
Note: these settings might be overruled by label software.
Speed
Density
Paper width
Paper height
Media Sensor
Gap
Gap Offset
Post-Print action
Cut Piece
Code Page
Maximum Length
Reference
Direction
Offset
Shift X / Y
Print speed (1 – 6 inch/s)
Printing temperature (0 - 15)
Media width in millimeters
Media height in millimeters
Gap / Black mark / Continuous
Gap size (height) in millimeters
Offset distance in millimeters
TEAR / PEAL / CUTTER / REWINDER /OFF
Cut after “X” labels
Keyboard country code
Maximum label detection length
Adjust print and tear-off position
Print direction (0 or 1)
Adjust tear-off position
Adjust print position
Printer selection
Select the printer(s) you want to apply the settings. This can be a specific printer or all printers.