Altek SR1128 - UNIT Display Unit C and Switches; HND Manual Control

SR1128 operation manual
~29~
then data log is stopped, and card signal blinks.
5. 9 UNIT Display unit
o
C and 

switches
Setup steps:
To select menu UNIT, “UNIT” displays on the screen.
►Press “SET” button to access program, “UNIT
o
C”
appears and “
o
C” blinks.
►Press “+” “-” button to switch unit between
o
C and
o
F,
factory set is
o
C.
► Press “ESC” button to exit the menu or wait for 20
seconds to exit automatically, parameters are saved
automatically.
5.10 HND Manual control
When using this controller first time or when debugging this controller, output of this
controller(P1, H1˅can be triggered manually with “On, OFF” control.
Setup steps:
To access main menu HND,
-------------------------------------------------------------------------------------------------------------------------
►Press “SET” button, “HND1 off” displays on the screen, P1 output manually set
►Repress “SET” button, “HND1 on” displays on the
screen, P1 output is switched-on
►Repress “SET” again, “HND1 off” displays, P1
output is switched-off
►Press “ESC” to exit P1 setup.
---------------------------------------------------------------------------------------------------------------
►Press “+” button, “HND2 off” displays on the screen,
P2 output manually set
►Press “SET” button, “HND2 on” displays on the
Short message Code
Description
FSYS
File system error
NOCRD
NO card
FAT16
Memory of card is less than 2G
FAT32
Memory of card is larger than 2G
RTIME
Left log time (in days)
LOGI
Data save interval( in minutes)
LOGG
LOG is possible
WRITR
Card written protection