O&C MANUAL #8311 • TH/III FAMILY
PG. 2
SECTION 1 INSTALLATION SECTION 1
1200-TH/III Installation Requirements:
Permanent wiring for this model series
must be installed by a licensed electrician
in accordance with applicable, local
electrical codes.
Tether Attachment for Permanent Wiring:
A) A permanently connected appliance, with casters
attached, must be tethered to the building structure,
in two places, to limit movement of the appliance
without depending on or transmitting stress to the
electrical conduit.
B) A hole on each side of the rear center grill, lower
flange, is provided for attaching two tether cables.
The other end of each should be anchored to the wall
structure with hardware sufficient to withstand 200
pound pull. (1/16" aircraft cable and 1/4" x 2" lag
bolts are recommended.)
C) The appliance shall be installed using flexible conduit,
with system meeting requirements of National Electric
Code for appliance rating. International units should
meet national or country code.
Beeper
Ports
Upper
Lower
Printer
Ports
Upper
Lower
Power
Switch
Power
Inlet
Upper Cavity
Hi-Limit Reset
Upper Cavity
Software ID
Tag
Sample
Lower Cavity
Software ID
Tag
Rating and
Certification
ID Tag
Double Cavity Oven
Top Back View
Double Cavity Oven
Mid-Section Back View
Ambient
Chamber Fan
Holes for Lanyard Tether
Cord Attachment
Lower Cavity
Hi-Limit Reset
Cord Connection for Semi-Permanent Installation:
A) Use UL listed (or appropriate for country of
installation) grounding type plug with integral
cord grip that is rated for 250 Volts, 30
Amperes, Single Phase, and 10 gauge cord with
insulation system meeting codes for installation.
B) Conductors of supply cord must be connected to
terminal block marked L1 and L2 with greater
length for ground lead to center terminal
marked GND.
To Next Page
Loading...
