OPERATION
Prodigi™ ▪ Operator’s Manual ▪ MN-47965 ▪ Rev 1 ▪ 5/23
79
Continued from previous page
3. Plug the USB drive 1 into the port.
4. Scroll to “System Backup & Update.”
Touch the “Update System Software” 2 setting.
Touch “Update Back End Software” to update the supporting software
between the control board (CB) and interface board (IB). The oven loads the
selected software.
Touch “Update Front End Software” to update the user interface software.
The oven loads the selected software.
Touch “Update Control Board (CB)” to update the control board. The oven
loads the selected software. The oven verifies the file and then updates the
CB.
Continued on next page
NOTICE
Do not remove the USB drive during the update
process.
To Next Page
Loading...
