SAFETY
Prodigi™ ▪ Operator’s Manual ▪ MN-47965 ▪ Rev 1 ▪ 5/23
9
Safety Precautions
Before you begin Read and understand all instructions in this manual.
Electrical precautions Obey these electrical precautions when using the appliance:
▪ All electrical connections must be made by a qualified and trained service
technician in accordance with applicable electrical codes.
▪ Consult local codes and Specification Sheets for the electrical cable and breaker
size.
▪ Power source must match voltage identified on appliance tag.
▪ CE-approved appliances include an equipotential-bonding terminal marked with
the equipotential symbol.
▪ For CE models, use a Type B current protection device that accommodates a
leakage current of 30mA.
Gas precautions Obey these gas precautions when using the appliance:
▪ Only use the oven when the exhaust hood is turned on.
▪ Keep the area around the oven clear of any obstructions that might slow down
the flow of cooling air.
▪ Do not place objects near the oven’s exhaust vents.
▪ Do not touch the exhaust vents while the oven is running or immediately after it
has been turned off.
▪ Do not spray aerosols in the area of the oven during operation.
▪ Do not store flammable materials in the area of the oven.
Usage precautions Obey these usage precautions when using the appliance:
▪ Only use this appliance for its intended use of heating or cooking.
▪ Always keep liquids, or foods that can become liquid when heated, level and at or
below eye level where they can be seen.
▪ Use utensils and protective clothing such as dry oven mitts when loading and
unloading the appliance.
▪ Use caution when using the appliance. Floors adjacent to the appliance may
become slippery.
▪ If the appliance is installed on casters, freedom of movement of the appliance
must be restricted so that utility connections (including gas, water, and
electricity) cannot be damaged when the unit is moved. If the appliance is
moved, make sure that all utility connections are properly disconnected. If the
unit is returned to its original position, make sure that any retention devices and
utility connections are properly connected.
Continued on next page
To Next Page
Loading...
