December 1997 17 RS1300003 Rev. 0
User Operation
Glass Shelves
Caution
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following steps:
1. Dilute mild detergent and brush solution into
crevices using a plastic bristle brush. Let set for 5
minutes.
2. Spray warm water into crevices using faucet spray
attachment.
3. Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering front.
Light Bulbs
WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After replacing
light bulb, connect power.
Caution
To avoid personal injury or property damage, observe
the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Upper Fresh Food Section
• Remove light bulb cover by removing ¼" hex nut
screws. Replace bulb(s) with 40-watt appliance
bulb(s).
• Replace light bulb cover by replacing ¼" hex nut
screws.
A
B
A. Light bulb cover B. Light bulbs
Lower Fresh Food Section (Some models)
• Remove light bulb cover by removing screw.
Replace bulb with 40-watt tubular bulb.
• Replace light bulb cover by placing cover over
light bulb. Insert and tighten screw.
A
B
C
A.Light bulb B.Light bul cover
C.Screw
Deepfreeze
®
Section
1. Remove ice bucket by lifting bucket and pulling
out.
2. Remove light bulb cover by removing screw.
Replace bulb with 40-watt appliance bulb.
3. Replace light bulb cover by holding cover in place
over light bulb. Insert and tighten screw.
4. Replace ice bucket by sliding in until bucket locks
in place.
A
B
A. Light bulb cover B. Light bulb
Ice ‘N’ Water
™
Dispenser (Some models)
Light bulb is located between dispenser arms.
• Remove light bulb by unscrewing light bulb.
Replace light bulb with a 6-watt, 120-volt bulb.
• Replace light bulb by inserting and tightening bulb.
To Next Page
Loading...
Need help?
General
