Amana SRD25S3 - December

December1997 73 RS1300003 Rev. 0
I. NO ICE/LOW ICE PRODUCTION (cont.)
5. Check Ejector Position (cont)
B. 3:00 Ejector Position
1.
Contamination 1. Replace Ice Maker Module
2.
Cube Jammed (Notice Size of Cube, Hollow?) 2. Un-Jam Cubes
3.
Ice Maker or Refri
g
erator Not Level 3. Level as Needed
4.
No Power To Ice Maker 4. Trace Power to Determine Discontinuit
y
5.
Excessive Water-Fill Volume (Lar
g
e Cubes) 5. Adj. Volume Screw on Module, Chan
g
e Water Valve or
Lower Pressure
6.
Rack of Cubes Fell Back Into Mold Durin
g
Ejection
6. Install New Fill Cup, Check Fill Tube Ass
y
.
C. 4:00 Ejector Position
1.
Contamination 1. Chan
g
e Ice Maker Module
2.
Thermostat out of calibration 2. Chan
g
e Out Thermostat, Appl
y
Fresh Coat Of Alumilastic
3.
Open Heater Circuit (Motor Should be
Oscillatin
g
)
3. Chan
g
e Mold/Heater Ass
y
, Appl
y
Fresh Coat Of
Alumilastic
4.
Little/No Alumilastic on Thermostat 4. Appl
y
Fresh Coat Of Alumilastic
5.
Heater Not Staked In Mold 5. Chan
g
e Mold/Heater Ass
y
, Appl
y
Fresh Coat Of
Alumilastic
6.
Broken Lockin
g
Tabs on Vertical Cam 6. Chan
g
e Module
D. 6:00 Ejector Position
1.
Contamination 1. Chan
g
e Ice Maker Module
2.
Hollow Cubes 2. Refer to Section III, "Hollow Cubes"
3.
Insufficient Water To Ice Maker, Small Cubes 3. Refer to Section III, "Hollow Cubes"
E. 7:30 Ejector Position
1.
Contamination (Motor Will Not Oscillate) 1. Chan
g
e Ice Maker Module
2.
Bail Arm Stuck in Ice or Obstructed 2. Remove Obstruction, Replace Ice Maker Module
3.
Pac-Man Cubes (Cubes not formed properl
y
) 3. Un-Jam Unit, Check Fill Cup And Fill Tube Ass
y
.
F. 9:00 Ejector Position
1.
Contamination 5. Chan
g
e Ice Maker Module
2.
Cube Frozen to Fill Cup or Mold 5. Un-Jam Unit, Install New Fill Cup and Module
Ice Maker Troubleshooting Chart