Amana SRD25S3 - Page 74

RS1300003 Rev. 0 74 December 1997
II. OVER PRODUCTION OF ICE
1. Bail Shut-off Arm Not in Actuator 1. Replace Bail Shut-off Arm in Actuator, Note for Loose
Fit
2. Misformed Bail Shut-off Arm 2. Replace Bail Shut-off Arm
3. Shut-Off Lever Broken or B
y
passin
g
Vertical Cam 3. Replace Ice Maker Module
4. Broken Module Actuator 4. Replace Ice Maker Module
III. HOLLOW ICE CUBES
1. Water Fill Volume Too Low 1. Adj. Screw On Module, Clear Water Path Or Chan
g
e
Water Valve
2. Improper Freezer Air-Flow 2. Re-Direct Air Flow Awa
y
from Ice Maker Thermostat
3. Thermostat Out Of Calibration 3. Chan
g
e Thermostat, Appl
y
Fresh Alumilastic
IV. FLOODING OR ICE SLABS IN BUCKET OR FREEZER
1. Thermostat Out Of Calibration 1. Chan
g
e Thermostat, Appl
y
Fresh Alumilastic
2. Jammed Cube Stalled In Water-Fill C
y
cle 2. Remove Cube, Determine Reason For Stall
3. Leak
y
Water Valve 3. Chan
g
e Water Valve
4. Fill Volume of Water Valve Excessive 4. Chan
g
e Water Valve
5. Motor Stalled In Water-Fill C
y
cle (12:00 Ejector Position) 5. Chan
g
e Ice Maker Module
6. Contaminated Module 6. Chan
g
e Ice Maker Module
7. Refri
g
erator or Ice Maker Not Level 7. Level As Necessar
y
8. Excessive Water Pressure 8. Lower Water Pressure (20-120 psi) (1.4 - 8.2 bar)
9. Module Shut-Off Switch and Contacts Shorted And
Burned
9. Chan
g
e Ice Maker Module
10. Broken Lockin
g
Tab On Verticle Cam (Stalled in
Waterfill)
10 Chan
g
e Ice Maker Module
11. Fill-Tube Not Properl
y
Located In Fill Cup 11 Reposition Fill Tube
12. Fill Cup Water Openin
g
Flashed Over/Plu
gg
ed 12 Chan
g
e Fill Cup
13. Cubes Fell Over Back Of Ice Maker, Meltin
g
Into
Freezer
13 Install New Fill Cup
Ice Maker Troubleshooting Chart