Construction and function of the sprayer boom
96
UF02 BAG00225.3 09.22
Working with the sprayer boom folded out on one side
Only possible with hydraulic preselected folding (optional).
See operating manual for software ISOBUS.
The sprayer boom is fully folded out.
1. Actuate tractor control unit.
Raise the boom to a medium height.
Swing compensation locks automatically.
2. Preselect the boom on the operating terminal which is to be
folded in.
3. Actuate tractor control unit green.
The selected boom folds in.
WARNING
After folding in, the boom lifts into the transport position.
Interrupt the folding process at the right point.
4. Align the sprayer boom using tilt adjustment so it is parallel to
the target surface.
5. Set the spraying height for the sprayer boom such that the
sprayer boom is a minimum of 1 m off the ground.
6. Switch off the part width sections of the folded-in boom.
7. During spraying operation, drive at a significantly reduced speed.
After one-sided spraying:
8. Cancel the preselection on the operating terminal.
9. Actuate tractor control unit green until
the folded-in boom is fully folded out again.
the swing compensation unlocks.
10. Switch all part width sections back on.
To Next Page