EasyManuals Logo

Ambient Weather WS-07 User Manual

Ambient Weather WS-07
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Version 1.0 ©Copyright 2013, Ambient LLC. All Rights Reserved. Page 6
Figure 5
1. Temperature
2. Min/Max Record mode
3. Temperature, Rate of Change indicator
4. Temperature units (°F or °C)
5. Humidity, Rate of Change indicator
6. Relative Humidity (%)
7. Humidity Comfort Icon
8. Reception Icon (solid when searching, flashes when
updating)
9. Channel 1,2,3,4,5,6,7,8, indictor
2.3.2 Sensor Operation Verification
Verify the indoor and outdoor humidity match closely with the console and sensor array in the same
location (about 5 to 10’ apart). The sensors should be within 10% (the accuracy is ± 5%). Allow
about 30 minutes for both sensors to stabilize. The humidity can be adjusted or calibrated later to
match each other a known source.
Verify the indoor and outdoor temperature match closely with the console and sensor array in the same
location (about 5 to 10’ apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow
about 30 minutes for both sensors to stabilize. The temperature can be adjusted or calibrated later to
match each other or a known source.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ambient Weather WS-07 and is the answer not in the manual?

Ambient Weather WS-07 Specifications

General IconGeneral
BrandAmbient Weather
ModelWS-07
CategoryThermometer
LanguageEnglish

Related product manuals