EasyManuals Logo

Ambient Weather WS-0802 User Manual

Ambient Weather WS-0802
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Version 1.0 ©Copyright 2017, Ambient LLC. All Rights Reserved. Page 4
Figure 2
3. Channel Number: The sensor supports up to eight transmitters. To set each channel number
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F vs.
°C), change Dip Switch 4, as referenced in Table 1.
DIP SWITCH
FUNCTION
1
3
4
DOWN
DOWN
---
Channel 1
DOWN
UP
---
Channel 2
DOWN
DOWN
---
Channel 3
DOWN
UP
---
Channel 4
UP
DOWN
---
Channel 5
UP
UP
---
Channel 6
UP
DOWN
---
Channel 7
UP
UP
---
Channel 8
---
---
DOWN
°F
---
---
UP
°C
Table 1
5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on
the display, as shown in Figure 3.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ambient Weather WS-0802 and is the answer not in the manual?

Ambient Weather WS-0802 Specifications

General IconGeneral
BrandAmbient Weather
ModelWS-0802
CategoryThermometer
LanguageEnglish

Related product manuals