Version 1.0 ©Copyright 2017, Ambient LLC. All Rights Reserved. Page 6
4 Display Console Set Up
Move the remote sensor(s) about 5 to 10’ away from the display console (if the sensor is too close, it
may not be received by the display console).
If you have more than one remote sensor, make sure they are all powered up and transmitting on
different channels. Remove the battery door on the back of the display, as shown in Figure 5.
Figure 5
Remove the battery cover, and insert two AAA (alkaline or lithium, avoid rechargeable unless fully
charged and high quality) batteries in the back of the display console. All of the LCD segments will
light up for a few seconds (to verify all segments are operating properly).
1. Replace the battery door, and place the console in the upright position with the desk stand
folded out.
The console will instantly display time and indoor temperature as designated. The remote
temperature will update on the display within a few minutes on the appropriate channel.
While in the search mode, the remote search icon will be constantly displayed.
If you have more than once remote sensor (up to eight remotes are supported), the display
will automatically toggle between sensors until all sensors have reported in.
To Next Page
Loading...
Need help?
General
