What to do if operating control levers produces no movement of Amco Veba 804 Construction Equipment?
If operating the control levers produces no movement, check the following: * Confirm there is motive power. * Ensure the switch key is inserted and the green light is on. * Disengage the emergency push-button after checking there are no dangerous conditions. * If the safety solenoid valve is damaged, go to an authorized workshop.
Why does Amco Veba 804 crane decrease in efficiency?
If your crane decreases in efficiency, the oil temperature increases, and it's necessary to increase the speed of the truck engine to obtain the required lift, it may be due to pump wear. Check the pressure on the pump delivery. If it’s necessary to replace it, go to an authorized workshop.
What to do if Amco Veba Construction Equipment crane moves slowly?
If the crane moves slowly, it could be due to a crushed or dented suction hose, in which case you should replace the suction hose. It may also be caused by air suction; check the tightness of the fittings on the suction hose.
What to do if Amco Veba 804 crane fails to lift required load?
If the crane fails to lift the required load with all movements, it may be due to a worn, unsealed, or dirty general overpressure valve. Also, oil leakage at some part of the circuit can be the cause. In both cases, go to an authorized workshop.
What to do if Amco Veba 804 Construction Equipment crane lifts, but does not hold the load?
If the crane lifts but does not hold the load, it could be due to a wrong boom valve setting, so set the valves. Alternatively, worn cylinder seals could be the cause, in which case you should replace the seals.
What to do if Amco Veba 804 crane does not complete its movements?
If the crane does not complete its movements, it may be due to a low oil level. Restore the oil level in the tank.
General| Brand | Amco Veba |
|---|---|
| Model | 804 |
| Category | Construction Equipment |
| Language | English |
To Next Page
