Revision 2
5
With proper installation, basic operation is straightforward:
1.) Set the bandswitch to the desired band. This happens automatically in the REM position
with a suitable radio interface cable
2.) Set the exciter or transceiver to the desired power below 100-watts.
3.) Place the standby switch in the operate position
4.) Transmit, and watching Forward Power metering, be sure power does not exceed 1200-
watts on peaks.
5.) For high duty cycle modes and long transmissions, reduce power. The amplifier will
attempt to reduce power if the FETs approach safe limits.
To Next Page
Loading...
