Ametek 3050-AM - Communication Settings

User Interface | 4-7
Communication
Select communication setup.
Config
Communication
Node
Address
Baud Rate
RS-485
Mode
optional
Enter
Address
9600
19200
Two Wire
Four Wire
Node Address
Enter the address for RS485 serial communications ( 0 - 240). Address 240 is
reserved (see the “Special Addresses” section in Chapter 5 for details).
Baud Rate
Select the baud rate at which you transfer data (9600 or 19200). The default
is 9600.
RS-485 Mode (Optional)
Select 2-wire or 4-wire. The default is 4-wire.