A-2 | 3050-AM Moisture Analyzer
Con guring the 3050-AM
This section provides instructions for setting up your operating parameters
using the Configurator software.
General Tab
Use the General tab to view the current configuration and define parameters
for the analyzer and for PC communications (Figure A-1).
After initial setup, any changes to the analyzer communications pa-
rameters must be made using the Device Communications tab. These
changes must be made before you make any changes to the computer
serial port settings.
PC Communications
Click the Setup button to configure PC Communications. The Serial Port
Communication screen opens (Figure A-2).
Port Select the COM port on your computer where the connection
to the analyzer is installed.
NOTE
Figure A-1.
General tab Configurator
software.
Figure A-2.
PC Serial Communications
setup screen.
To Next Page
Loading...
