Ametek 5000

The sample gas may contain highly toxic and corrosive substances. Proper personal protective
equipment including fresh air breathing apparatus, eye protection, and skin protection MUST
BE worn when installing the sample tap and/or opening the lid for inspection or maintenance.
If sampe gases contain highly toxic and corrosive compounds, analyzed sample must be re-
turned to the process or vented to a safe area.
Cautions
Review and follow these Cautions to avoid damaging the equipment.
The electronic circuit boards and other static-sensitive components should be stored and trans-
ported in static-shielding carriers or packages.
For electrical-shock protection, the analyzer must be operated from a grounded power source
that has a securely connected protective-ground contact.
If it becomes necessary to handle any of the electronic circuit boards, do not subject the boards
to static discharge. The ideal solution is a static-safe work area. Since such areas typically
are not available at analyzer installation sites, the use of a wrist strap connected directly to a
ground is recommended. If a wrist strap is not available, you should at the very least touch the
metal chassis (to ground yourself) before handling or touching the boards.
Take extreme care to avoid damaging the threads on the cable entry glands. Clean, defect-free
threads are essential to ensure a flameproof connection.
The lid weighs 8.2 kg (18 lb). Use proper lifting methods and wear protective footwear when
removing.
!
CAUTION
!
WARNING
!
WARNING
!
CAUTION
!
CAUTION
!
CAUTION
!
CAUTION
Essential Health & Safety Requirements | 7