Ametek 900

Controller / User Interface | 4-7
• To return to CFG mode normal display from any menu in CFG mode,
press F6 0.
• When entering commands, the User Interface will return to CFG
mode normal display:
- If you press a Function key that is not valid for your system.
- If you press a numeric key that is not valid for your system.
• To return to RUN mode, press Esc. If any changes have been made
to the CFG mode settings, the message “SAVE CONFIG?” appears.
Press Ent to answer “Yes” and then press Esc again to return to RUN
mode. Or, press Esc to answer “No”. If no changes have been made,
the software will return immediately to the RUN mode.
Working in CAL Mode
While working in CAL mode, the following rules apply:
• A password must be entered (from RUN mode) to enter CAL mode.
• In “CAL mode normal display” “CAL” will be displayed on the top
line, along with all functions or results associated with this mode. The
output results from RUN mode will continue to be displayed on the
bottom line.
• When entering commands, the User Interface will return to CAL
mode normal display:
- If you press a Function key that is not valid for your system.
- If you press a numeric key that is not valid for your system.
IMPORTANT
Pressing Ent after making any changes (while working in the CFG
or CAL mode) will cause the configuration data to be saved in non-
volatile memory – the old values will be lost.
If the configuration data are not saved, the previous configuration
data will be used following a system reset or power-up.

NOTE