6-8 | Model 900 ADA / Model 930 Sulfur Pit Analyzers
Oven Heater Spare Parts
This list includes all of the possible parts that may be required as part of
maintenance on the Oven Heater Plate. These parts are required only in
the event of failure, loss, or damage to the part. Quantity of parts is deter-
mined by the number of parts required. Contact AMETEK if these parts
are required.
Part No. Description
300-4924 RTD
†
300-4914 RTD Base *
‡
300-4913 RTD Tip *
‡
300-8684 Heater Element
300-4182 High Temperature Wire, 16 AWG, 30"
300-4182 Ring Terminal, #8
300-0265 Lock Washer, 4 mm
300-0006 M4 x 8 Screw
300-4478 Loctite 271
†
Used for internal Overtemp and Heater RTDs, and external Sample Cell RTD (or Sulfur Condenser RTD, if used).
‡
Used for external Sample Cell RTD (or Sulfur Condenser RTD, if used).
* Required only if lost or damaged (re-use if not damaged).
Refer to drawings in “Optical Bench Chopper Assembly Maintenance” diagram in Chapter 5.
Ordering a Hard Copy of the Analyzer Operator’s
Guide
To order a hard copy of the analyzer Operator’s Guide and the entire
Documentation Package, use the Part Number below:
Part No. Description Qty
903-8745 Model 900 / Model 930 Analyzer Operator’s Guide 1
To Next Page
Loading...
