Ametek NetWave 20 User Manual

AMETEK CTs NetWave
8.5.6. Fuses NetWave 108.x
The fuses are located at the rear side of the NetWave behind the cover. For replace the user must open the
screws at the cover.
F1…F3 Fuses for General Input Line R, S, T
Rated voltage: 500 V
Rated current : 315 A
Type : NH2 gL / gG ITALWEBER 162031
Breaking capacity: >100 kA
F4 – F 12 Fuses for Line Inverter phase unit R, S, T
Rated voltage: 400 V
Rated current : 125 A slow blow
Dimension : 14 x51 mm
Type : SCH14 gG ITALWEBER 1431100
Breaking capacity: >120 kA
14x51mm
F13 – F 21 Fuses for Charge resistor
Rated voltage: 500 V
Rated current : 1 A slow blow
Dimension : 10 x 38 mm
Type : aM Legrand
Breaking capacity: >100 kA
10x38 mm
F22, F 23 Fuses for Input Auxiliary Transformer
Rated voltage: 500 V
Rated current : 8 A slow blow
Dimension : 10 x 38 mm
Type : aM Wimex
Breaking capacity: >120 kA
10x38 mm
F24, F 25 Fuses for Output Auxiliary Transformer
Rated voltage: 250 V
Rated current : WGT 15 A slow blow
Dimension : 5 x 20 mm
5x20 mm
F26 - F 28, Fuses for Controller
F32, F36
Rated voltage: 250 V
Rated current : WGT 6.3 A slow blow
Dimension : 5 x 20 mm
5x20 mm
F29 – F 31, Fuses for Aux. Supply Inverter Phase R, S, T and Fan
F33 – 35, F37-F39
Rated voltage: 250 V
Rated current : WGT 2.5 A slow blow
Dimension : 5 x 20 mm
5x20 mm
F40, F41 Fuses for Safety Circuit
Rated voltage: 250 V
Rated current : WGT 1 A slow blow
Dimension : 5 x 20 mm
5x20 mm

Ametek NetWave 20 Specifications

General

Brand	Ametek
Model	NetWave 20
Category	Industrial Equipment
Language	English