Ametek NetWave 20 User Manual

AMETEK CTs NetWave
5.2.23. Language
Selection of the desired language.
English : Default setting
German : Change to German language
5.3. Warning and Alarm
5.3.1. Warning
If the user starts a programmed wave manually at the NetWave where the
actual power setup does not fit the programmed wave.
The display shows a warning with the proposed power settings.
Remedy
1a. Press SETUP for direct enters the power setup or alternative
1b. Press STOP button for exit and press SETUP
2. Change the power setting with SETUP...
3. Start the test again.
5.3.2. Alarms
NetWave alarms are coded in binary values. The NetWave software will
decode the messages separately and show it at the computer screen.
In NetWave display the alarm is indicated in an addition of the binary error
codes
Remedy
1. Press STOP button
2. Check the alarm reason
- change the SETUP?
- Problem in power supply?
- Problem with EUT?
Binary values of the alarms

Ametek NetWave 20 Specifications

General

Brand	Ametek
Model	NetWave 20
Category	Industrial Equipment
Language	English