Ametek NetWave 20 - Functions; 4.1. Front Panel Controller Overview

AMETEK CTs NetWave
4. Functions
4.1. Front view controller
1 LED Trigger
2 LED Running
3 LED Power
4 Test ON Button
5 Mode
6 Start
7 Stop
8 Cursor "" "→"
9 Setup
10 LED output active L1 or Lines L1/L2/L3
11 Output plugs High / Low / PE ( NetWave 3/7)
12 Display
Power on switch
Power ON switch for NetWave. The system needs
approx. 35 seconds for booting.
1. LED Trigger
The LED Trigger indicates
- Manual, external or remote trigger event
- Start of a sequence
2. LED Running
The LED Running indicates the running play- or
measuring status
3. LED power
The LED power indicates the power on status.