AMETEK CTs NetWave
4.2.2. Rear view NetWave 7.3
The upper part of the NetWave is the control part. The control plugs are at the rear side of the NetWave
available.
Additionally, to the other models, the NetWave 7.3 has two additional BNC Connectors (17) which allows
extended functionality (see annex 9.2).
1 Ventilator controller part
2 Framebus IN / OUT
3 Serial from DPA 500N / 503
4 Trigger IN1 / IN2
5 Trigger OUT1 / OUT2
6 Ethernet port
7 USB port
8 DUT monitor
9 GPIB / IEEE 488 port
10 Heat Sink air output
11 Ventilator ( output)
12 Safety circuit
13 Fuse 3.15 A slow blow ( ctrl)
14 Mains in CEE 32 A 3x400 V
15 Sense input
16 Test supply output
17 Arbitrary Generator Signal
Output & Input
17 Sync out – Source Input
Connection from the arbitrary generator to the amplifier.
In case of using an external signal generator., the Signal must connect to
source input BNC plug.
To Next Page
Loading...