Ametek NetWave 3.1 User Manual

AMETEK CTs NetWave
1. Safety
1.1. Safety Aspects
Observe all precautions to assure your personal safety. The generators comply with Installation Category II
(excess voltage section).
Pay special attention to safety and operation details!
1.2. Safety and warning label on the device
Please take note of the following explanations of the symbols used in order to achieve the optimum benefit from
this manual and to ensure safety during operation of the equipment.
This symbol warns of a potential risk of shock hazard. The symbol on an instrument
shows that that it can source 1000 volt or more, including the combined effect of
normal and common mode voltages. Use standard safety precautions to avoid
personal contact with these voltages.
This symbol indicates where a caution is required. Refer to the operating
instructions located in the manual in order to protect against personal injury or
damage the equipment.
GROUND Indicates protective Ground Terminal
*CAUTION”
The “CAUTION” symbol indicates a potential hazard. It calls attention to a
procedure, practice or condition which, if not followed, could possibly cause damage
to equipment. Such damage may invalidate the warranty. If a “CAUTION” is
indicated, do not proceed until its conditions are fully understood and met.
“WARNING”
The “WARNING” symbol indicates a potential hazard. It calls attention to a
procedure, practice or condition which, if not followed, could possibly cause bodily
injured or death. If a “WARNING” is indicated, do not proceed until its conditions are
fully understood and met.
Power Supply
If not stated otherwise, the equipment is intended to operate with a power supply not to exceed 250 volts
between phase and neutral or between phase and ground. A proper ground connection through the ground
connector of the power cord is essential for safe operation.
Grounding the Generators
The generators are grounded through the power cord. To avoid electric shock, plug the power cord into a
properly installed receptacle which was tested by a qualified electrician. Have the test performed before
connecting equipment.
Without the protective ground connection, all parts of the generators are potential electric shock hazards. This
may include components which appear to be insulated. The equipment MUST NOT BE USED if this protection
is altered.
Use the Proper Power Cord
Use only power cords and connector specified for your product. Use only power cords in good condition.
Use Proper Fuses
To avoid fire hazard, use only fuses as specified in the parts listing for your product - matching type, voltage and
current rating.
Do Not Remove Covers or Panels
To avoid personal injury, do not operate the generators without panels and covers.

Ametek NetWave 3.1 Specifications

General

Brand	Ametek
Model	NetWave 3.1
Category	Industrial Equipment
Language	English