AMETEK CTs NetWave
4.5. Functions on NetWave 7.3, 20.x, 30.x, 60.x, 67.x, 90.x, 108.x
4.5.1. Setup Menu
These NetWave models offer in the setup menu additional functions:
Select Operation Mode.
Standard: Operating with software
Simple AC: Operating with external commands from a XML file
Source AC: AC Synchronization with an external rectangular signal
External: Analogue signal generation with an external signal generator
* This Menu is only with a NetWave 7.3, 20, .20.2, 20.3, 30, 30.2, 30.3, 60, 60.2, 60.3, 90.2, 90.3 available
4.5.2. Simple AC Mode
In the Simple AC Mode, The NetWave can run locally stored XML Simple Wave Files (XYZ.ssa) or receive
commands by remote.
The programmable Trigger Signal in the Simple AC mode is provided to Trigger Out 2
(Max. voltage: 24V (pull up) / Current: 100mA)
XML Simple Wave Files describes a selection of phenomenon to be played, which is easy to read and write for
the User. All these Files are manually written by the User and can be managed through remote commands.
The management of the commands must be done by the User or by third party software through the GPIB or
Ethernet connection of the NetWave.
For detailed information about XML Simple Wave Files and programming code, please refer to the separate
User Manuals; XML Simple Wave File and Remote Manual, which are delivered with NetWave .
To Next Page
Loading...