Ametek Sorensen XFR 7.5-300 - Page 14

TM-F2OP-C1XN-01 xiii
Table 1-1 Available Voltage and Current Ranges - - - - - - - - - - - - - - - - - - - - - - - - 1–2
Table 1-2 Rear Panel SW1 Switch Assignments - - - - - - - - - - - - - - - - - - - - - - - - - 1–6
Table 1-3 Rear Panel J2 Connector Terminals and Functions - - - - - - - - - - - - - - - - 1–8
Table 2-1 Basic Setup Procedure - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–2
Table 2-2 Operation AC Input Voltage Range and Frequency- - - - - - - - - - - - - - - - 2–6
Table 2-3 AC Wire Specification - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2–6
Table 2-4 Current Carrying Capacity for Load Wiring- - - - - - - - - - - - - - - - - - - - 2–13
Table 2-5 Rear Panel J10 Sense Connector Terminals and Functions - - - - - - - - - - 2–22
Table 3-1 Shipped Configuration (Local Control Mode) - - - - - - - - - - - - - - - - - - - 3–5
Table 3-2 Switch Settings for Shutdown Circuit Logic- - - - - - - - - - - - - - - - - - - - 3–10
Table 3-3 Switch Settings for Over Temperature Recovery Options- - - - - - - - - - - 3–17
Table 4-1 Remote Programming Options- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4–3
Table 4-2 Power Supply Settings for Different Programming Sources - - - - - - - - - - 4–5
Table 4-3 Settings for Remote Monitoring of Readback Signals - - - - - - - - - - - - - - 4–7
Table 5-1 User Diagnostics - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5–10
Table A-1 Specifications for 7.5 V to 40 V Models - - - - - - - - - - - - - - - - - - - - - - - A–2
Table A-2 Specifications for 60 V to 600 V Models- - - - - - - - - - - - - - - - - - - - - - - A–4
Tables