M O D E L 2 1 7 W D R
O P E R A T O R ’ S M A N U A L
32
4. The TACK PARAMETERS screen will be displayed. You can select the amount of
PENETRATION PERCENTAGE (0% to 126%) desired, the NUMBER OF TACKS (1 to 40)
desired, and the TACKING PATTERN – SEQUENTIAL (consecutive) or BALANCED (180
degrees opposite each other) desired. Press O.K. when set.
5. The AUTO SCHEDULE NAME screen will be displayed. The default schedule name is
based on the tube O.D., wall thickness and material you entered when creating this weld
schedule. You may save it as is or use the keypad to assign your own personal weld
schedule name. Press SAVE when finished.
To Next Page
Loading...
