USER’S MANUAL
AMIKO MINI HD265
AMIKO MINI COMBO EXTRA
Remote Sensor: Detects infrared signal from remote control unit.
POWER Indicator: Lit whilst the receiver is powered on and at standby mode.
Signal Indicator: When received signal is strong, the signal indicator is lit.
Card Slot: One CA Interface for Conax.
USB (on the side): USB 2.0 Host, connect to USB hard disk, or flash disk,and 3G dongles.
Display: (LED type) Indicates operating status of receiver.
RS 232 (on the side): This is used to connect your receiver to a computer through a serial cable.
IR IN( on the side): Connect an External IR-Sensor (Infrared).
POWER Indicator: Lit whilst the receiver is powered on and at standby mode.
Signal Indicator: When received signal is strong, the signal indicator is lit.
Card Slot: One CA Interface for Conax.
Common Interface: One socket for Conditional Access Modules CAM.
USB A: USB 2.0 Host, connect to USB hard disk, or flash disk,and 3G dongles.
Display: (LED type) Indicates operating status of receiver.
Remote Sensor: Detects infrared signal from remote control unit.
POWER Indicator: Lit whilst the receiver is powered on and at standby mode.
Signal Indicator: When received signal is strong, the signal indicator is lit.
Card Slot: One CA Interface for Conax.
USB (On the side): USB 2.0 Host, connect to USB hard disk, or flash disk,and 3G dongles.
Display: (LED type) Indicates operating status of receiver.
AMIKO MIRA WIFI
Remote Sensor: Detects infrared signal from remote control unit.
POWER Indicator: Lit whilst the receiver is powered on and at standby mode.
Signal Indicator: When received signal is strong, the signal indicator is lit.
Card Slot: One CA Interface for Conax.
USB (On the side): USB 2.0 Host, connect to USB hard disk, or flash disk,and 3G dongles.
Display: (LED type) Indicates operating status of receiver.
7
To Next Page
Loading...
