Amkus iC550 - 11 Troubleshooting; General; Troubleshooting the Motor; Troubleshooting the Hydraulics

©Copyright Task Force Tips LLC 2016-2020 23 LAI-001 November 5, 2020 Rev06
11.0 TROUBLESHOOTING
11.1 GENERAL
Malfunctions can be divided into three sections:
1. Malfunction of the electric motor
2. Malfunction of the hydraulic system
3. Malfunctions related to other rescue tool components or systems
Remedies marked by the letter M require the intervention of the Maintenance Technician.
Remedies marked with the letter O can be performed by the Operator.
11.2 TROUBLESHOOTING THE MOTOR
Table 11.2
11.3 TROUBLESHOOTING THE HYDRAULICS
Table 11.3
12.0 PARTS, SERVICE, AND TECHNICAL INFORMATION
Parts, service, and technical information may be obtained from your local AMKUS dealer, or at amkus.com
13.0 DECOMMISSIONING
When decommissioning any AMKUS Rescue Systems Tool or power supply, follow local regulations. For proper disposal information,
contact your local AMKUS Rescue Systems dealer.
NOTICE
Immediately remove malfunctioning or damaged tools from service. Consult your dealer or AMKUS
Rescue Systems.
ALL SERVICE MUST BE PERFORMED BY QUALIFIED SERVICE TECNICIANS IN OBSERVANCE OF
SAFETY REGULATIONS.
PROBLEM POSSIBLE REASON POSSIBLE REMEDY PERFORMED BY
MOTOR DOES
NOT START
Battery defective Replace battery O
Tool not turned on Press the power button
for 3 seconds
O
Battery not charged Charge battery O
PROBLEM POSSIBLE REASON POSSIBLE REMEDY PERFORMED BY
ELECTRONC
MOTOR
OVERHEATED
Battery overheated Allow battery to cool O
Cooling vents obstructed Clean cooling vents O
PROBLEM POSSIBLE REASON POSSIBLE REMEDY PERFORMED BY
STROKE DOES
NOT BEGIN
Control valve actuator damaged Replace control valve M
MOTOR DOES
NOT STOP
Battery shorted Replace battery O
Control valve actuator stuck Blow out control valve with
air/Consult Authorized
AMKUS Service Tech
M,O
STROKE
DISCONTINUOUS
Max. pressure valve fault Consult AMKUS Service
Department
M,O