Amkus iC550 - 14 Inspection, Cleaning, Decontamination, and Storage

©Copyright AMKUS Rescue Systems 2016-2020 24 LAI-001 November 5, 2020 Rev06
AMKUS RESCUE SYSTEMS
AMKUS.com
4201 Montdale Drive, Valparaiso, IN 46383-4098 USA
800-592-6587 · 219-548-5000
14.0 INSPECTION, CLEANING, DECONTAMINATION, AND STORAGE
1. Always store the tool securely in a clean, cool, dry space.
2. Relieve the pressure on the tools after use by backing off the end stop.
3. Remove the battery from the tool.
4. Charge the battery.
BEFORE BEING PLACED BACK IN SERVICE, the rescue tool must be inspected to this list:
1. Check to see that all rescue tool markings are legible.
Contact your local dealer or AMKUS Rescue Systems for replacement labels.
2. Wipe the tool clean.
3. If the rescue tool becomes contaminated, determine the nature of the contamination. Follow the decontamination guidelines
provided by the Authority Having Jurisdiction. Technical advice may be requested from AMKUS Rescue Systems.
4. Inspect the tool, controls, and battery after each use for damage, leakage, and excessive wear.
5. If rescue tool damage or excessive wear is noticed, remove the rescue tool from service immediately.
Contact your local dealer or AMKUS Rescue Systems for service.
6. Install battery and verify tool operation.
Products manufactured in Italy and USA.
WARNING
Any equipment failing any part of this checklist is unsafe for use and must have the problem
corrected before use or being placed back in service. Operating equipment that has failed the
checklist is a misuse of this equipment. Contact your local AMKUS dealer or AMKUS Rescue
Systems.