©Copyright AMKUS Rescue Systems 2016-2020 4 LAI-001 November 5, 2020 Rev06
TABLE OF CONTENTS
1.0 MEANING OF SAFETY SIGNAL WORDS
2.0 SAFETY
3.0 GENERAL DESCRIPTION
3.1 VARIOUS MODELS AND TERMS
3.2 SAFETY MARKINGS
4.0 SPECIFICATIONS
4.1 GENERAL SPECIFICATIONS
4.2 CUTTER SPECIFICATIONS
4.3 SPREADER SPECIFICATIONS
4.4 COMBI TOOL SPECIFICATIONS
4.5 TELESCOPIC RAM SPECIFICATIONS
5.0 SAFETY CONSIDERATIONS
5.1 PROTECTIVE CLOTHING
5.2 TRAINING
5.3 OPERATING CONSIDERATIONS
6.0 SET-UP PROCEDURE
6.1 CHARGE THE BATTERY
6.2 INSTALL THE BATTERY
6.3 POWER BUTTON ON/OFF
6.4 ROTATING HANDLE
6.4.1 HANDLE LIGHTS
6.5 CONTROL VALVE ACTUATOR
7.0 OPERATION
7.1 BATTERY CHARGE STATUS
7.2 WHEN TO CHANGE THE BATTERY
7.3 STORAGE RECOMMENDATIONS
7.4 CUTTING
7.5 SPREADING / SQUEEZING / LIFTING
7.6 TELESCOPING RAM OPERATION
8.0 ACCESSORIES
8.1 RAM EXTENSIONS
8.2 EXTENDED REACH SPREADER TIPS (ERT)
8.3 CHAIN USE
9.0 SAFETY GUARDS
10.0 INSPECTION AND MAINTENANCE
10.1 ROUTINE MAINTENANCE
10.1.1 CHECK THE BLADES
10.1.2 HYDRAULIC MAINTENANCE
10.1.3 MOTOR MAINTENANCE
10.1.4 LUBRICATION
10.1.5 HANDLE LIGHT BATTERY REPLACEMENT
11.0 TROUBLESHOOTING
11.1 GENERAL
11.2 TROUBLESHOOTING THE MOTOR
11.3 TROUBLESHOOTING THE HYDRAULICS
12.0 PARTS, SERVICE, AND TECHNICAL INFORMATION
13.0 DECOMMISSIONING
14.0 INSPECTION, CLEANING, DECONTAMINATION, AND STORAGE
To Next Page
Loading...
