AML Oceanographic AML-3 - Log Parameters; Instrument Time and Location; Power Management

For example, entering 10 with the sample unit
set to seconds would result in a sample taken
every 10 seconds. Changing the sample unit
to /second would result in samples taken 10
times per second.
Pressure Increment
Available when pressure increment is set as
the sample trigger. Sets the pressure
increment (in dBar) when a sample should be
taken.
Sound Increment
Available when sound velocity is selected as
the sample trigger. Sets the sound velocity
increment (in m/s) when a sample should be
taken.
3.2 Log parameters
These settings control which parameters are included in the data stream and the generated log
file. Note that some parameters require specific sensor configurations to be calculated. Options
include date, time, density, salinity, calculated sound velocity, battery, depth, and raw values.
3.3 Instrument Time and Location
Setting
Description
Date and Time Source
Select the clock to synchronize the
instrument to. Options are the connected
computer’s clock, or GPS.
Location Mode
Select the GPS source to synchronize the
instrument to. Options are Instrument
(internal GPS), manual (external GPS), and
none.
3.4 Power Management
Setting
Description
In-Water WiFi Sleep
Specify if the WiFi chip should be disabled while
underwater or not.
In-Water WiFi Sleep Timeout
(secs)
The amount of time before the WiFi chip will be disabled
once the instrument detects that it is underwater.
Power Timeout
Specify if the instrument should turn itself off if left idle.
AML Oceanographic Ltd. 20 / 43