AML Oceanographic AML-3 - GPS Commands

<hh:mm:ss>
set wapstop <delay in
seconds>
Set the in-water stop timeout for the WiFi access point in
seconds. When the instrument is in water, it will disable the
WiFi access point to save power. This setting configures the
delay between the in-water detection and disabling WiFi.
Setting the delay to 0 disables this feature.
display memory
Print the SD card’s total and used memory in bytes.
display version
Print the version header, including the model name,
firmware version, serial number, and total space of the
installed SD card.
display volt
Print the current battery voltage.
secure on
Enables the user to send “secure” commands. Secure mode
is not persistent through multiple telnet sessions or a power
cycle.
5.10 GPS commands
Command
Description
gps
Print location and other GNSS information in the following
format: <date> <time> <latitude> <longitude> <#satellites>
<hdop>
fullsync
Synchronize the instrument’s date and time to GNSS date
and time.
set location <mode>
Set the instrument’s location mode. Options are gps, man,
or non.
gps uses GPS to determine the location
man makes the location user configurable
non disables the location
If man is enabled, set latitude and set longitude can be used
to set the instrument’s location.
set latitude <latitude>
Set the instrument’s latitude location. This command always
changes the instrument’s manual latitude setting, even if not
in manual mode. The instrument only uses this setting to
determine its location if in manual location mode.
set longitude <longitude>
Set the instrument’s longitude location. This command
always changes the instrument’s manual longitude setting,
even if not in manual mode. The instrument only uses this
AML Oceanographic Ltd. 30 / 43