● Older AML Xchange™ sensors with blue locking sleeves are not compatible with the
AML-3 and AML-6 line of instruments.
● CT X2Change™ should be installed in port 1 on both the AML-3 and AML-6 due to the
mechanical fit between the sensor and the cage. All other X2Change™ sensors can be
installed in any of the remaining sensor ports.
● A sensor riser (1.5” and 2.5” options available) may be required when installing a CT
X2Change™ if other tall X2Change™ sensors are installed nearby.
8.3 Seals and Plugs
Before deployment, ensure that every empty X2Change™ sensor port is sealed with the
X2Change™ Blanking Plug, the USB-C port is capped, and each MCBH is plugged with its
dummy plug or cable. Contact AML Support to replace lost plugs or caps.
To Next Page
Loading...
