AMSAFE SEATBELT AIRBAG SYSTEM
INSTALLATION, HANDLING & SHIPPING INSTRUCTIONS E510629
SHIPPING, TRANSPORTATION, HANDLING, STORAGE PROCEDURES
02-Aug-2013
Page 4005
F. Packaging and Shipping Requirements – Inflator
WARNING:
FAILURE TO COMPLY WITH ALL RELEVANT DANGEROUS GOODS
REGULATIONS REGARDING THE INFLATOR MAY RESULT IN CIVIL OR
CRIMINAL PENALTIES.
NOTE:
FOR REGULATED MATERIALS TRANSPORTATION – COMPLIANCE WITH
APPLICABLE TRANSPORTATION REQUIREMENTS IS STRICTLY THE
RESPONSIBILITY OF THE END USER AND NOT OF AMSAFE.
(1) Use the original packaging material in which the Inflator was received, if available and when it
is in a serviceable condition. The Inflator must be shipped in a container which is DOT
approved having been UN tested and marked under UN Performance Oriented Packing (POP).
A new UN POP container may be requested in the RMA process.
(2) External Packaging
(a) Use only UN POP shipping container.
(3) Exterior Labels and Markings
(a) Labels
1. The exterior container shall be labeled durably and legibly to show at least:
All appropriate hazmat labels per Title 49 CFR Section 172.400.
All appropriate labels required by country of shipping origin.
(b) Markings
1. The exterior container shall be marked durably and legibly to show at least:
All appropriate hazmat markings per Title 49 CFR Section 172.300.
All appropriate markings required by country of shipping origin.
2. Markings such as RMA number and ship-to/from addresses shall be placed to avoid
loss or obstruction during opening and closing of the container.
(4) Shipping
(a) Any person performing shipping functions for the Inflator must be trained in accordance
with the requirements contained in Title 49 CFR Section 172.700.
(b) All local and relevant international handling, shipping, transporting regulations must be
followed.
(c) Ship the component to AmSafe address as determined from previous paragraph 3E.
(d) EX Numbers for shipping Inflators:
INFLATOR P/N DESCRIPTION EX NUMBER
507592-401 TRW, ROI, 3.0 Mole EX2001100059
508795-401
508794-401
TRW, ROI-V2, 2.3 & 3.1 Mole,
90 Degree Fitting
EX2004030191
508792-401 TRW, ROI-V2, 2.3 MOLE EX2007020369
510385-401 TRW, ROI-V2, 2.3 MOLE 45
Degree Fitting
EX2007020372
To Next Page
Loading...