AMSAFE SEATBELT AIRBAG SYSTEM
INSTALLATION, HANDLING & SHIPPING INSTRUCTIONS E510629
SHIPPING, TRANSPORTATION, HANDLING, STORAGE PROCEDURES
02-Aug-2013
Page 4007
(4) Exterior Marking
(a) The exterior container shall be labeled, tagged or marked durably and legibly to show at
least:
Ship-to/from address
RMA Number
EMA – Lithium cells or batteries may be transported by ground or air. If being
transported by ground, proper labeling identifying the battery must be present. If
being transported by air, it must be done so as Class 9 Material.
(c) RMA number and ship-to/from addresses shall be placed to avoid loss or obstruction
during opening and closing of the container.
(5) Shipping
(a) All local and relevant international handling, shipping, transporting regulations must be
followed.
(b) Ship the component to AmSafe address as determined from previous paragraph 3E of
this section. Consult your supervisor for the correct shipment method applicable at your
location.
(c) Contact Shipping Department any questions regarding shipping @
shipping@amsafe.com or (602) 850-2768.
4. STORAGE
A. Inflator
(1) The Inflator shall be stored in cool and dry environments. Acceptable storage temperature
should not exceed 200 degrees F (93-degrees C). The Inflator should be protected from
sunlight, dust, moisture, and other contamination.
(2) The Inflator shall be protected from excessive EMI/RFI/ESD environments.
(3) The Inflator shall be handled and stored by a person trained in the requirements associated
with dangerous goods.
(4) Observe all local storage regulations. Store only in a controlled area.
(5) The maximum continuous storage time for the Inflator is 10 years from date of manufacture.
The service life of the Inflator Assembly (expiration date) is determined by the date of
manufacture shown on the AmSafe label, not the Autoliv label. See Figure 15. If the EMA has
been reworked or refurbished, the label will show an expiration date and should be removed
and returned to AmSafe for disposal (once it has reached its expiration date).
NOTE:
ONCE THE INFLATOR IS INSTALLED IN ITS INTENDED LOCATION FOR USE
(SEAT), THE ASSEMBLY THAT CONTAINS THE INFLATOR IS NOT REGULATED
BY DOT.
To Next Page
Loading...