SafeWizard Operating Instructions American Security Products Company
Last Revision 10/17/2008 Page 37 of 73 Document 4305199
Chapter 3-2-2
Access Control-
Daylight Savings
By default the Daylight Savings is factory Enabled.
3-2-2.1 Access Control Menu
1 Door Access
2 Daylight Savings
3 Holidays
4 Penalty Lockout
5 PIN Life
6 Entry Doors
7 Man Trap Doors
QUIT
From the Access Control Menu, select 2 for Daylight Savings.
Note: Access to this screen requires permission only available to an
Administrator or Super User.
3-2-2.2 Daylight Savings Screen
D/L Saving Enabled
Starts on the 2nd
SUN in MAR at 02:00
Next Event 03/11/2007
Ends On the 1st
SUN in NOV at 02:00
Next Event 11/04/2007
NO: Disable QUIT: Save
If this SafeWizard is located somewhere that does not participate in
Daylight Savings, then it is important for this feature to be turned off.
After Selecting this screen, the cursor will be located under the last
word in line 2. Press the UP key to move the cursor up to the first
line. Press the NO key to change to “Disabled.” Press the
QUIT/SAVE key to save. Then press MENU and QUIT/SAVE to exit
to the LOCKED screen.
Future Daylight Savings Date Changes
The following is only required if there is a change from the current Daylight Savings schedule.
There are two changes that can be made in the event there is a change to Daylight Savings in the future.
First, is which Sunday of the month and second is which month. This applies to either Spring or Fall or
both.
Changing which Sunday:
Press the DOWN key to move the cursor to the second “Starts” or fifth “Ends” line. Press the NEXT key
or BACK key to move to the desired Sunday of the same month.
Changing which Month:
Press the DOWN key to move the cursor to the third line or sixth line. Press the NEXT key or BACK key
to move to the desired month.
After all changes have been made, press QUIT/SAVE key to save.
Then press MENU and QUIT/SAVE to exit to the LOCKED screen.
To Next Page
Loading...
