AMSEC SafeWizard - Set Installed Doors

SafeWizard Operating Instructions American Security Products Company
Last Revision 10/17/2008 Page 47 of 73 Document 4305199
Chapter 3-4-2-4
Factory Menus-
Locks & Doors-
Set Installed Doors
Set Installed Doors is used to configure the number of doors installed on a given system.
3-4-2-4.1 Locks and Doors Menu
1 Set Safe Locks
2 Set Door Sensors
3 Set Entry Doors
4 Set Installed Doors
5 Setup Deposit Lock
QUIT back
Press 4, Set Installed Doors.
3-4-2-4.2 Locks and Doors Menu
Set Quantity of
Installed Doors
Safe Doors 2
Entry Doors 0
BACK-QUIT
Modifying the number of doors installed on a system is done by typing
in the prescribed number of doors in the Safe Doors field. Pressing
the Quit key saves this setting. You will be automatically logged out
after modifying this setting.