AmTryke 1416 - Pedals

21
Pedals
Pedals are mounted onto the pedal
cranks. The right pedal tightens
clockwise and the left
counterclockwise. Hand thread until
you are certain that they are
threaded properly and then use a 15
mm wrench to tighten securely.
The length of the pedals can be adjusted (from 7 to 10 inches) as well as the
position of the pedals over the pedal cranks (toe-in or toe-out). To adjust the
pedal size, use a 10mm wrench on the nylock nuts on the bottom of the pedal.
Pedal and pedal crank
TIP: Pedal threads tighten toward
front of bike.
CAUTION: BE CAREFUL WHEN
THREADING PEDALS. DO NOT
FORCE. PEDALS THREAD EASILY
WHEN INSTALLED PROPERLY.
TIP: Pedals and pedal cranks are
labeled “R” (right) and “L” (left).
Adjusting pedals
TIP: Use a 10mm wrench to easily loosen
and tighten nylock nuts on bottom of
pedals.