Set the unit upright then ll and ush the water purier prior to use
7
a. Turn on cold water tap and switch handle to treated water
position.
b. Check for leaks.
c. Switch the handle to the untreated water position then turn o
the cold-water tap.
Note: It will take a short time for water to saturate the Filter
and start owing out of the faucet. Run for 5 minutes to
remove air pockets and carbon dust and if not clear, run
for another 5 minutes. If water does not begin to run clear,
see Troubleshooting.
Note: After each use, follow these steps to ensure proper
valve shuto.
Operation of the Diverter
If you installed a diverter on your faucet spout, the position of the handle controls the ow of the
water. The handle can be switched to three positions:
a. Treated water – straight stream.
b. Untreated water – straight stream.
c. Untreated water – shower.
15
To Next Page
Loading...
